Directed Directechs DB3 Instrukcja instalacji - Strona 11

Module programming

Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.

IMPORTANT!

Before programming your module, you must first check if your vehicle is equipped with an OEM

remote starter and disable it. If the vehicle is equipped with an OEM remote starter, whether Active or Inactive,

MUST

be temporarily disabled or permanently disconnected depending on the vehicle.

Please refer to the "OEM remote starter information" section of the guide for additional details.

Note:

In some cases, the module will program to the vehicle even if equipped with an OEM starter, but will

prevent the aftermarket remote start from functioning properly.

For

Security Only

and

Convenience only (skip transponder)

The following step must be followed in this exact order:

Connect the 14-pin.

Connect the 12-pin.

Connect the 10-pin.

When the LED turns on solid red, proceed with the next step.

Press the Push-to-Start (PTS) button twice (2x) to turn the ignition ON.

The LED will turn on solid green for 3 seconds, then shut off.

Note: If the LED starts to flash orange, it indicates the vehicle is equipped with a factory

remote starter. Refer to the "LED Diagnostics & Troubleshooting" section for more information.

The module is now programmed.

Press the PTS button one (1x) time to turn the ignition off.

You have successfully completed the module programming sequence.

403.TL3 4.12 2012 Lexus LS 460 (Smart Key)

programming, see next sections.