Directed Directechs DB3 Instrukcja instalacji - Strona 5

Pre-installation and application warnings

This section highlights important information for this specific firmware and will assist in pricing accordingly, as

START

HERE

well as bringing awareness to any operational or vehicle limitations.

Compatibilities and Requirements

T-Harness

T-Harness is not compatible.

compatible

Vehicle Takeover

Firmware notes

Keysense wire: Make sure you do not connect the keysense wire in the installation for each of these vehicles or you will encounter

issues when attempting to start the vehicle.

Fuses: It is important to check that the fuses are positioned correctly in the module. Proper fuse positioning is displayed on each wiring

diagram.

Refer to the Vehicle connections section following the installation diagram.

Footnotes

[1] Hood pin: The installation of an aftermarket hood pin is only required on vehicles that are not equipped with a factory

hood pin, or if not supported in data.

[2] Tach wire: Optional connection required on some remote starters, which do not support a tach signal in D2D. Also note that, by

default, the tach is set to 1000 rpm on hybrid vehicles.

[3] Autolights Interrupt: Connection only required if the vehicle is equipped with automatic headlights.

[4] TPMS Ignition Interrupt: Depending on the vehicle's trim, the TPMS Ignition Interrupt connection may be required to obtain OEM

remote functionality during runtime.

Note: the TPMS light may flash during runtime.

Some Toyota 2010+ models have different encryption types. Please look at your key blade and identify the markings.

H-stam ped keys

For vehicles with H-stamped keys, see

the TL10 firmware.

403.TL10 2.32 2015 Toyota RAV4 (H Key)

Refer to the Quick Reference Guide section for more details.

G-stam ped keys

For vehicles with G-stamped keys, see

the TL5 & TL7 firmware.

Keys required for

Keys required

programming

for operation

Standard Key

For vehicles with dot-stamped keys,

see the TL11 firmware.

Note:

Some replacement keys

may not have any markings on

the key.