Alecto DVC-150IPV2 Podręcznik użytkownika - Strona 10
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Kamera bezpieczeństwa Alecto DVC-150IPV2. Alecto DVC-150IPV2 17 stron.
Drukuj stronę
Changing Video Setting.
Video Setting: The following three items can be set here:
Video Quality, Video Flip en Environment Mode.
Video Quality: You can set the video compression and resolution here. The
Advanced Setting
following values can be selected: Maximum, Medium, and Minimum. The
Security Code Setting
Modify Security Code
standard High and Low have no function.
The highest quality image will be shown at the "Maximum" level. The minimum
Video Setting
Video Quality:
Max
image quality will be shown at the "Minimal" level. At the best picture level, an
Video Flip:
Normal
Environment Mode:
Indoor(50hz)
increased bandwidth is required for a faster connection. For a minimal image a
Sound Detection
lower bandwidth with a lower speed of the network should be sufficient. A slow
Sound Level:
off
Trigger Duration:
1 Seconds
connection used in combination with a too high bandwidth can cause a shock
Notification:
Ringtone and Vibrate
Event Setting
to the image resulting in a slight delay. It is advised to set a lower quality should
Motion Detection:
Off
this be the case.
Notification:
Ringtone and Vibrate
WiFi Setting
Video Flip: The picture mode can be adjusted here. You can choose from the
SSID:
None
Remote device no response
following settings: Normal, Flip, Mirror, and Flip & Mirror.
Manage Wi-Fi networks
Normal: Displays a normal picture.
Time Zone
Flip: The image will be turned 180°. If the camera is turned upside down for
example.
Device Information
Mirror: The picture will be shown as a mirror image.
Model:
P2PCam
Version:
0.0.1.18
Vender:
Alecto
Flip & mirror: The image displayed is mirrored and rotated 180°.
Total size:
15060 MB
Free size:
12897 MB
.
Cancel
Environment Mode: : Image settings depending on the brightness of the
surroundings. There is a choice of either Inside mode (50Hz), Inside mode
(60Hz), Outside or Night mode. Use the indoor mode (50Hz) when there is
bright light and Night mode in low or no light.
Sound Detection.
Sound Level: You can set the level of sound here for when an alarm is to be sent. The following
available sound levels are: Maximum, High, Medium, Low and Off.
Take Note: The alarm sound will not affect the sound of the volume when watching the live view. The
volume level must be set on your smart phone or tablet.
Trigger Duration: You can set the length of time here for the level of sound when an alarm message
is sent. It can be adjusted from between 1 to 5 seconds.
Notification: What alarm signal would you like to have? You can choose from: Silent, Sound,
Vibration, Sound and Vibration. The Vibration only works if supported by the smart phone or tablet.
10