Platform: DBALL2
Firmware:
CHRYSLER8 Remote Start Ready (RSR) Installation
LED Diagnostics & Troubleshooting
LED
Status
Module Programming
Off
Off
Solid red
Solid red
Solid orange
Solid orange
Flashes
Flashes green
green
Flashes orange
Flashes orange
quickly
quickly
Solid green
Solid green x3
x3
Solid orange
Solid orange x3
x3
Module Programming - Error codes
Flashes red
Flashes red x2
x2
Flashes red
Flashes red x3
x3
Flashes red x4
Flashes red
x4
External Module Synchronization
(Flashes red,
red, then orange)
(Flashes red, red,
x10
then orange) x10
Active Ground While Running (status)
Flashes
Flashes green
green
Flashes red &
Flashes red
& orange
orange
Flashes green
Flashes
green quickly
quickly
D2D and W2W Commands
Flashes orange
Flashes
orange x1
x1
Flashes orange
Flashes
orange x2
x2
Flashes orange
Flashes
orange x3
x3
RSR Code
Flashes red
Flashes red x7
x7
Description
Module has no power.
Waiting to begin the
programming sequence.
Bypass was skipped.
Vehicle (VIN) and key information
was received.
Vehicle information (VIN) was
received.
Module was successfully
programmed.
Module was successfully
programmed without bypass.
HS CAN not detected.
Bypass not detected.
Bypass processing error.
OBDII feature not supported.
GROUND OUT ON (GWR)
command received.
IGNITION ON command received.
START ON command received.
LOCK command received.
LOCK command received.
TRUNK command received.
3x OEM Lock Remote Start
Activation was attempted
when RFTD feature is
disabled.
Troubleshooting
Check the power connections. Make sure that the 12 Volt is
present between the red and black wires. If it is, the module may be
defective.
Make sure that all the connections are correct (refer to the Wiring
Diagrams).
Normal operation.
Normal operation. Waiting for key information.The user will
sometimes not see this LED pattern; all the information is usually
received together.
Normal operation. Waiting for key information.The user will
sometimes not see this LED pattern; all the information is usually
received together.
Normal operation.
Normal operation.
Check the Tan - Tan/Black connection. Turn the ignition on and try
again to activate the data bus. Convenience is on this bus.
Check the bypass line connection. If more than one wire is used,
make sure they are not inverted. Start vehicle using the key to
confirm the OEM equipment is still operational.
The second part of the information was not received. Turn the
ignition off then back on to try again. This might be caused by an
incorrect reading in the first programming attempt or by an unknown
bypass value. If a second or more attempt fails, connect the module
to Directechs and call Tech Support with the module ID in hand.
Diagnostic data bus not detected. Some features are not supported
by SmartStart. This can be caused by missing wire connections or
module hardware limitation. Refer to the wiring installation section
to check the connections.
Otherwise, the Ground While Running (status) signal was lost or
was never received by the module. Commands can come from RF,
D2D or W2W.
Otherwise, the ignition signal was not received by the module. In a
W2W install, it will show only if the ignition input wire is used.
Otherwise, the start signal was not received by the module. In a
W2W install, it will show only if the ignition input wire is used.
Normal operation
Activated from Web automatically when using RSR flash
tool or can be done manually. Refer to feature
programing section for more information.
Rev.: 20151126
Page 11
© 2015 Directed. All rights reserved.
Drukuj stronę