California Accent Lightning marketLITE ML2000-CM Instrukcja instalacji - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Światło robocze California Accent Lightning marketLITE ML2000-CM. California Accent Lightning marketLITE ML2000-CM 11 stron.
Drukuj stronęmarketLITE
Installation Instructions
1.
Install aircraft cable.
NOTE: See previous page for cable mounting details.
Cable lock
2.
Hook socket onto aircraft cable.
3.
Cut excess wire at end of run.
TIP: Use sharp wire cutters to create a clean cut and avoid fraying.
Sharp cutters
4.
Check that wires or strain relief cable are not touching.
TIP: Contact between any of the wires will result in a short.
Good
5.
Apply silicone to inside of end cap.
Apply silicone
(not included)
™
Mounting eye (not included)
Aircraft cable
Insufficient jacket covering.
Wires will touch inside end
cap and cause a short circuit.
CALIFORNIA ACCENT LIGHTING, INC.
2034 E. Lincoln Ave. #431, Anaheim, CA 92806
ph. 800.921.CALI (2254) or 714.535-7900 \ fx. 714.535.7902
[email protected] \ calilighting.com
© CALI. All rights reserved. CALI reserves the right to make changes or withdraw specifications without prior notice.
6.
Fully insert wires into end cap.
TIP: Allow silicone to seep out of end cap for a proper seal.
Check the silicone seal for holes or gaps.
NOTE: Silicone must be non-conductive and weatherproof
Silicone seeps
out around edge
7.
Install bulbs into sockets, then install cages into canopies.
NOTE: Do not over-tighten bulbs.
Over-tightening compromises weather seal, damaging internal components.
NOTE: A small amount of the screw threads will show between socket and bulb.
Do not attempt to screw bulb beyond this point.
8.
Cut lead wire to desired length.
Use sharp cutters to ensure clean cut
ML2000-CM
Step by Step
Small gap
7 of 11