Clarke 3120193 Instrukcja obsługi i konserwacji - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Sander Clarke 3120193. Clarke 3120193 17 stron. Multi-sander kit
Drukuj stronę
SANDING AND GRINDING TIPS
• Do not force the disc or stone against the material.
• The key to efficient grinding is to control the pressure and surface
contact between the grinding tool and the workpiece.
• Allow the tool to reach full speed before grinding.
• Avoid overloading the grinder. If it becomes hot during use, rest for a
few minutes while it cools down.
TROUBLESHOOTING
SYMPTOM
Tool runs at normal
speed but slows down
under any load.
Tool runs slowly. Air
flows weakly from
exhaust.
Tool will not run. Air
flows freely from
exhaust.
Tool will not shut off.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
PROBLEM
1. Excessive pressure on
tool.
2. Motor parts worn.
3. Worn or sticking
mechanism due to
lack of lubricant.
1. Motor parts jammed
with gum/dirt.
2. Regulator in closed
position.
3. General airflow
blocked by dirt.
1. Motor vanes stuck
due to buildup of
foreign material.
1. Throttle O-rings
damaged or ill-fitting
in seat.
10
SOLUTION
1. Reduce the force
applied to the tool.
2. Return to Clarke dealer
for repair.
3. Drip air tool lubricating
oil into the air inlet. Allow
oil to soak the moving
parts before using.
1. Examine inlet air filter for
cleanliness.
2. Adjust the regulator to the
open position.
3. Operate the tool in short
bursts.
1. Disconnect air supply
and rotate tool assembly
manually.
2. Try operating tool in
short bursts.
3. Drip a few drops of air
tool lubricating oil into
the air inlet to soak moving
parts.
1. Return to Clarke dealer
for repair.