Aleko AR2000 Podręcznik użytkownika - Strona 11

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Otwieracz do bram Aleko AR2000. Aleko AR2000 16 stron.

AR2000 SLIDING GATE OPERATOR

Adding extra remote controls (Learn): Press the button 'AN' (See Fig.9 terminal 17) on the

control board, then the 'LED2' will be on and turn off, the beeper will ring about 1 second,

then press the remote control button which you want to use, the 'LED2' will turn on and

then turn off again, the beeper will ring about 2 seconds. The learning process is finished.

Up to 100 remote controls may be used.

Erase remote controls: To erase all existing remote controls, press and hold 'AN' button,

the beeper will ring, release the button once the beeper stops ringing. This indicates that

all the remote controls have been erased completely.

NOTE: For safety and security, we recommend that the factory setting be replaced with a

personal code.

Press the 'OPEN' button of external button switch or remote control button which has been

programmed, the gate will open, the motor rotates clockwise, the output voltage between

'D' and 'D' is AC110V, the voltage between 'U' and 'V' is AC110V. Press 'STOP' button or

the same remote control button, the gate stops running. Press 'CLOSE' button or the same

remote control button again, the gate will close, the motor rotates anticlockwise, the output

voltage between 'D' and 'D' is AC110V, the voltage between 'U' and 'W' is AC110V. Press

the 'STOP' button or the same remote control button, the gate stops running.

Verify open direction: If the gate does not move in the desired direction, then you will need

to reverse the motor operating direction, you can do this by exchanging wires 'V' and

'W', 'OP' and 'CL'.

Position

DIP-switch

OFF

Button 3

Fig.10 Remote control

Table 2 DIP-switch

(See Fig.9 terminal 18)

Programming / In this position the control board is in

programming condition, NOT USE condition.

Normal / In this position the control board can be normally used.

Auto-close function and auto-close function of pedestrian mode

are available.

Both Auto-close function and auto-close function of pedestrian

mode are shut off.

Limit switch mode is NC.

Limit switch mode is NO.

Button 1

Button 2

Button 4

Function