Clarke Super E Edger Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sander Clarke Super E Edger. Clarke Super E Edger 16 stron. American sanders

Drukuj stronę

1. Pad

OPERATING INSTRUCTIONS

4. Gradually lower pad to surface intended for

sanding. Make sure the machine is in motion

while the pad is engaged with the surface to be

sanded. You may use broad circular motion as

you sand along the length of the surface or your

may use a combination of forward and sideward

motions. In time you will develop your own

technique to optimize coverage and dust recov-

ery. It is advisable to not add effort to the pad as

this may lead to "nosing in" or "tipping" which

produces grooves or lines on the surface.

5. When replacing abrasive, emptying the contents

of the dust bag, or sanding operation is com-

pleted, return machine to reclined position, flip

control switch to "Off" then disconnect the motor

pigtail from the supply cable.

6. Empty dust bag whenever it becomes 1/3 full.

DANGER: Failure to disconnect the supply cable

from machine whenever servicing,

replacing abrasive, or emptying the

dust bag could result in electrocution

or severe injury. Never leave machine

unattended while the supply cable is

connected.

DANGER: Never leave dust bag unattended with

sanding dust in it. Sanding dust can

spontaneously ignite and cause a fire

or explosion. Empty dust bag into a

metal container, clear of any combus-

tibles. Do not empty content into a

fire. Do not overfill dust bag.

ADJUSTMENT PROCEDURES

Leveling

To level machine: Place screwdriver in slot on caster

stem to prevent rotation. Use a 3/4 wrench to loosen

locknut. (Figure 4)

Condition - Pad creates ridges on both edges or a "hop" is

experienced: Rotate both stems equal amounts clock-

wise. Tighten locknuts and test on a piece of plywood.

Repeat procedure until condition is corrected. We

recommend you not exceed 1/8" rotation for each at-

tempt.

Condition - Pad creates a ridge on the tip of the pad:

Rotate both stems counter clockwise, tighten locknuts

and test. Repeat procedure until condition is corrected.

Use only 1/8 rotation for each attempt.

Page 8

Figure 4

American Sanders Super E Operator's Manual

Clarke