Clarke Woodworker CBS1-5 Instrukcja obsługi i konserwacji - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Sander Clarke Woodworker CBS1-5. Clarke Woodworker CBS1-5 15 stron. Belt/disc sander
Również dla Clarke Woodworker CBS1-5: Instrukcja obsługi i konserwacji (17 strony)
Drukuj stronę
•
With the table secured, position the
Disk Cover/Dust Extraction Port as
shown, with the locating pin on the
cover 'A', engaged in the slot in the
hinged cover 'B'.
•
Secure with four screws (arrowed)
3. Feet
The four feet may be very gently eased into the holes at the base of the machine.
Alternatively, the machine may be mounted on a workbench or a wooden base, using
the four holes in the base as mounting holes. In order to maintain complete stability
when in use, the wooden base should be secured to a workbench using 'G' clamps.
Important Adjustments - Before Use
1. Belt Table Adjustment
•
With the belt correctly tensioned (see
Maintenance), adjust the Belt
Support so that it is square and bears
very lightly on the back of the
Sanding Belt.
Ensure the two hex socket head
securing screws (arrowed) are tight.
A hex. socket wrench is provided.
•
Slacken the Table Locking Lever and
position the table so that a gap of 2-
3mm exists between the slot in the
table and the belt, then lightly secure
the table using the locking lever.
•
Place an engineers square on the table
so that it butts up against the belt, then
unlock the adjuster by unscrewing the
locknut at 7B. Screw the adjuster 7A,
clockwise or anticlockwise whilst
bearing down on the table at a point
adjacent to screw 7A, until the square
indicates that the table is at right angles.
•
Lock the adjuster, ensuring the nut is
tight, then, maintaining pressure on the
table, finally secure the table using the
locking lever. by turning anticlockwise.
•
Finally, check to ensure the gap
between the table and belt is 2-3mm.
9
5
6
7