Directed Electronics 410S Instrukcja obsługi - Strona 18

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Alarm samochodowy Directed Electronics 410S. Directed Electronics 410S 20 stron. Directed electronics, inc. owner's guide

Drukuj stronę

QUICK REFERENCE GUIDE:

To arm/lock using your remote

Pressing

for one second will arm the system and lock the doors.

The red LED will begin to flash once per second. The Failsafe® Starter

Kill will prevent the vehicle's starter from cranking if it has been in-

stalled. The vehicle's horn (if connected) will honk and the parking

lights will flash once to confirm arming of the system.

To disarm/unlock using your remote

To disarm the system and unlock the doors, press

The Failsafe® Starter Kill will be deactivated and the vehicle's horn (if

connected) will honk twice and the parking lights will flash twice.

Disabling the Failsafe® Starter Kill without a transmitter

To do this, you must have the vehicle's ignition key and know where the

Valet® switch is. Be sure to check with the installer for the location of

the Valet® switch. Turn on the ignition. Press and release the Valet®

switch, within 10 seconds. The LED will stop flashing and the vehicle

should start.

To enter or exit Valet

Turn the ignition to the "on" position. Turn the ignition back off. Press

and release the Valet® switch within 10 seconds. The Status LED will

light steady if you have entered Valet® Mode. To exit Valet® Mode,

repeat the steps above. The LED will turn off when exiting Valet® Mode.

To activate panic mode

Press and hold

down for 1.5 seconds.

To exit panic mode

Press

Mode

for one second.

1999 Directed Electronics, Inc.