Clarke 7236046 Instrukcja obsługi i konserwacji - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Pompa wodna Clarke 7236046. Clarke 7236046 13 stron. 750w submersible pump with built-in float switch
Drukuj stronę
ASSEMBLY
Remove all packaging and make sure that the unit has no visible damage.
Dispose of all packaging appropriately.
FITTING THE ELBOW
1. Screw the elbow into the outlet
port as shown.
2. Connect a suitable hose (not
supplied) to the pump outlet.
• Suitable hoses are available
from your local Clarke dealer.
FITTING THE HOSE ADAPTOR
A 4 step adaptor is supplied.
The hose adaptor can be screwed
onto the elbow if required.
1. Trim the adaptor to the required
size.
• Reducing the hose diameter
will effect the maximum flow
rate.
2. Connect a suitable hose (not
supplied) to the pump outlet.
• Suitable hoses are available from your local Clarke dealer.
SETTING UP THE PUMP
POSITIONING THE PUMP
1. Place the pump on a flat surface in the area that you want to drain.
• If there is sediment in the operating area, the pump should be placed
vertically on house bricks, or similar.
• ALWAYS raise and lower the pump using a rope attached to the lifting
handle.
• Take all necessary precautions as described on page 3.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
5