Clarke CWP200 Instrukcja obsługi i konserwacji - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Pompa wodna Clarke CWP200. Clarke CWP200 13 stron. Submersible clean water pump
Drukuj stronęSAFETY INSTRUCTIONS
GENERAL
1. Read all these instructions before use and save them for future reference.
2. An approved residual current device (RCD) which has a tripping current of
less then 30mA MUST be used for all operations.
3. The electrical supply must be the same as that on the rating plate.
4. ALWAYS make sure that your hands are dry when connecting or
disconnecting from the mains supply.
5. NEVER pull the mains lead to disconnect the pump from the mains socket.
6. The mains plug must be kept away from the water at all times.
7. Do not allow children or unauthorised people to touch the pump/cable.
8. Disconnect the pump from the mains supply when not in use.
9. If necessary have the pump repaired by a qualified person.
10. Keep the mains lead away from heat, oil and sharp edges.
11. If you have to use an extension lead with this product, it must be designed
for outdoor use and incorporate a cable suitable for use with Class I
appliances.
12. Disconnect the pump from the electrical supply and wear gloves during
servicing or maintenance.
PUMP SPECIFIC
1. Do not pump explosive / flammable liquids or chemicals.
2. NEVER allow the pump to run dry or operate out of the water.
3. Submersible pumps should always be submerged and stored vertically.
4. Disconnect the pump from the mains supply before placing it into or
removing it from the water.
5. ALWAYS check the plug, and all cables for damage before use.
6. Do not use the pump if damaged. Refer to qualified service personnel for
repair.
7. NEVER carry or lower the pump by the power cable or float switch always
use the handle or a rope tied securely to the handle.
8. NEVER use the submersible pump in a swimming pool when there are
people or animals in the pool.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
4