Alemite 595-D Instrukcja serwisowa - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Narzędzia Alemite 595-D. Alemite 595-D 8 stron. Cordless grease gun
Drukuj stronęSER 595-A
CAUTION
Do not expose the Charger to rain, snow, or frost. To
reduce the risk of damage to electric plug and
cord, pull by the plug rather than the cord when
disconnecting the Charger.
Make sure the cord is located so that it will not be
stepped on, tripped over, or otherwise subjected to
damage or stress.
Do not operate the Charger with damaged cord or plug.
Replace immediately.
Do not operate the Charger if it has received a sharp
blow, been dropped, or otherwise damaged in any way.
Do not disassemble the Charger.
Do not charge the Battery when the temperature is
below 40° F (4°C) or above 104° F (40°C).
The Charger is designed to operate on standard
household electrical power. Do not attempt to use it on
any other voltage.
Consecutive charging may cause overheating. If you
need to recharge the Battery consecutively, wait for
about 15 minutes to allow the Charger to cool.
Do not insert foreign material into the hole for the
Battery in the Charger stand.
Do not disassemble the Battery.
Do not Store the gun and Battery assembly in
locations where the temperature may reach or exceed
104°F (40°C).
Do not short-circuit the Battery.
Do not place the Charger in an area of extreme heat
or cold. It works best at normal room temperature.
Declares that under the sole responsibility for supply of the machinery described as:
TYPE/SERIES:
MODEL:
These products are in compliance with the following European Community Directives: 2006/42/EC
The following standards were used to verify compliance with the directives:
EN60745, EN60335-1, EN60335-2
Approved by: ________________________________________ Date: ______________________________
Director of Engineering: Robert Hoefler
Revision (05-12)
EC DECLARATION OF CONFORMITY
ALEMITE, LLC
167 Roweland Drive
Johnson City, Tennessee, USA 37601
Cordless Grease Gun
595-A, 595-B, 595-C, 595-D
8
Battery Charger Operation
Charge the Battery only with the Charger provided.
Make sure power circuit voltage is same as that shown
on the charger specifications plate. Press down to
ensure the battery properly engages with the charger's
contacts.
Function of Red and Green Lights
Red Light Flash
When the charger is powered on, the Red light
will flash once.
Green Light Flashing
Charging
Green Light On
Battery fully charged
Red Light Flashing at 4HZ
Battery will not charge
Red Light Flashing at 1HZ/5HZ
Battery too hot. Charging will restore when the
battery pack cools down to 104° F (40° C).
Battery overheating could be attributed to:
A. Long continuous running
B. Hot ambient temperature
C. One or more cells are damaged
One hour of charge time is required to fully
charge the battery.
The Battery will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
December 14, 2011
Cordless Grease Gun
Alemite, LLC