Alemite 8120 Series Instrukcja serwisowa - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Narzędzia Alemite 8120 Series. Alemite 8120 Series 6 stron. Large capacity hose reel
Drukuj stronę
SER 8120
Personal Safety
Personal injury and/or equipment damage may result if
proper safety precautions are not observed.
WARNING
• Even low pressure can cause irreparable
damage or death. Exercise extreme caution
while operating or servicing this Equipment.
• Ensure that reel is properly installed before
connecting supply line (see instructions).
• Before connecting supply line to reel, ensure
that supply line pressure does not exceed
maximum rated working pressure of reel.
• Do not wear loose fitting clothing while
operating reel.
• Be aware of other personnel/machinery in work
area.
• If a leak occurs in hose or reel, remove supply
line pressure immediately.
• Pull hose by grasping the hose itself not by the
control valve swivel.
• If reel ceases to unwind or rewind properly,
remove power immediately. Do not pull or jerk
on hose. Find and remedy problem before
continuing.
• Treat and respect a hose reel as any other
piece of machinery, observing all common
safety practices.
• Prevent Static Sparking. When working around
flammable liquids such as solvents, paints,
chemicals or petroleum products, ensure that
the hose reel and the equipment being
serviced is properly grounded. Use a
grounding hose (static wire).
• Use an ohmmeter to check continuity of the
grounding circuit. Fire and/or explosion can
result if proper grounding is not achieved.
• If reel is electric driven, check for loose, frayed
and broken wires before operating.
• If reel is electric, air or hydraulic driven, be
careful of chain/sprocket drive system. Keep
hands clear and do not wear loose fitting
clothing while operating reel.
Revision (9-11)
To order call 1-800-548-1191 or visit www.partdeal.com - [email protected]
Mounting
1. Unpack and inspect reel - rotating spool (1) to check
for smooth operation.
2. Ensure that mounting surface is rigid and flat to
prevent binding of reel after it is installed. This is
important to ensure proper alignment.
3. Secure reel to mounting surface by inserting four
bolts (2) through the four mounting holes (3) in the
reel frame. Tighten securely to ensure solid, rigid
attachment.
Figure 2 Large Capacity Hose Reel - Mounting
Electric Driven Reels
WARNING
• Remove all electrical power when wiring.
• DO NOT "HOT WIRE".
• Observe all applicable NEC, OSHA, and
local codes.
NOTE: It is not proper to connect either
power lead to any part of the motor, or to
any part attached to the motor, such as the
terminal box, as that would make the
motor an integral part of the electrical
power circuit.
2
Large Capacity Hose Reel
Alemite LLC