Clarke 01193B Instrukcja obsługi - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Maszyna podłogowa Clarke 01193B. Clarke 01193B 20 stron. Ultra speed burnisher
Drukuj stronę
120 VOLT MACHINES
Instructions for connection to the power
supply and the electrical ground.
This product must be grounded. If it should
malfunction or breakdown, grounding provides a path
of least resistance for electric current to reduce the
risk of electrical shock. This product is equipped
with a cord having an equipment-grounding conductor
and grounding plug. The plug must be inserted into
an appropriate oulet that is properly installed and
grounded in accordance with all local codes and
ordinances.
WARNING:
Improper connection of the
equipment-grounding conductor can
result in a risk of electric shock. Check
with a qualified electrician or service
person if you are in doubt as to whether
the outlet is properly grounded. Do not
modify the plug provided with the
product. If it will not fit the outlet, have a
proper outlet installed by a qualified
electrician.
This product is for use on a nominal 120 volt circuit
and has a grounding attachment plug that looks like
the plug illustrated in Figure 1. Make sure that the
product is connected to an outlet having the same
configuration as the plug. No adaptor should be
used with this product.
WARNING: To prevent possible electric
shock, protect the machine from rain.
Keep the machine in a dry building.
WARNING: To prevent possible electric
shock, always use a 3-wire electrical
system connected to the electrical
ground. For maximum protection
against electrical shock, use a circuit
that is protected by a ground fault circuit
interrupter. Consult your electrical
contractor.
WARNING: Do not cut, remove or break
the ground pin. If the outlet does not fit
the plug, consult your electrical contrac
tor.
WARNING: Have worn, cut or damaged
cords replaced by an authorized service
person.
EXTENSION CORDS
Use only an approved extension cord with three
conductors, a plug with three terminals, and a
connector body with three holes. The machine has a
power cord with wire size 14 AWG.
WARNING: If you use an extension
cord, use an extension cord with
minimum wire size 12 AWG. Do not use
an extension cord longer than 50 feet.
Do not join two extension cords.
CLARKE TECHNOLOGY Operator's Manual - Ultra Speed Burnisher 1700
GROUNDED
OUTLET
GROUNDING
PIN
Figure 1
GROUNDED
OUTLET BOX
Page -5 -