Directed Electronics 20402 Podręcznik użytkownika - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla System bezpieczeństwa Directed Electronics 20402. Directed Electronics 20402 8 stron. Vats / passlock / transponder universal alarm bypass module

Drukuj stronę

TRANSPONDER / PASSKEY 3 / P.A.T.S.:

'Smart Key' & other Transponder systems

Note: For this type of security system - you must sacrifice one of

the spare keys that comes with the car. This key will be used

for the transponder. The dealership can progam a spare key,

but make sure they program all keys to the vehicle since

learning just one transponder could erase all other key tran-

sponders (including the key used for the Bypass Module).

1. Set all dip switches on the bypass module to the OFF (up)

position.

2. Remove the transponder from the key (there maybe a door

on the top of the key that can be opened and the transpon-

der can be removed). Or, the entire key may be mounted

inside the Bypass Module. Be sure to cut the key in half or

grind off some of the teeth to render it unusable.

3. Pull apart the case and place the transponder, or the head of

the key, inside the 10 wire loop on the circuit board. Tran-

sponders are directional and must be placed along the same

direction that the key would lay. Use the double stick foam

tape provided -- one layer on the circuit board and then the

transponder, or key, and finally the second double-stick foam

tape layer on top of it to hold key securly in place.

Place Key with Transponder inside case on pc

board as shown. Use double stick tape to hold

to the key in place.

v2.1

4. The transponder LOOP goes underneath the steering col-

umn and up toward the ignition key cylinder and needs to

be positioned so that there are 2 turns around the ignition

key cylinder as shown below. Transponder systems often

have a black plastic ring around the ignition lock switch.

This is the vehicle's transponder pick-up antenna. It is im-

portant that the two loops of the Bypass Module be mounted

on or as close to this black plastic ring as possible. Slide

the tube up toward the ignition switch to tighten up the loops

of wire. Tape in place to hold. Plug the other end of the

transponder loop into the Universal Alarm Bypass Module.

5. Now start the vehicle with the remote starter. If the vehicle

starts and runs for at least 30 seconds the transponder by-

pass is correct. Note: If the vehicle does not start with the

remote starter, try adjusting or changing the position of the

transponder in the Bypass Module or adjusting the position

of the two loop wire around the transponder pick-up an-

tenna mentioned above.

Note: The key that the transponder was removed from will no

longer start the vehicle.

v2.1