Directed Electronics Viper Audio d2500.1 Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Directed Electronics Viper Audio d2500.1. Directed Electronics Viper Audio d2500.1 20 stron. Directed electronics, inc power amplifier owner's manual

Drukuj stronę

REAR PANEL CONNECTIONS

1. R R e e m m o o t t e e T T u u r r n n O O n n - This terminal turns

on the amplifier when (+) 12 volt is

applied to it. Connect it to the remote

turn on lead of the head unit or signal

source. If a (+) 12 volt remote turn

on lead is not available, a Remote

Power Adapter (P/N #55000) can

be used to supply a remote turn on

signal. DO NOT connect this terminal

to constant (+) 12 volt.

2. S S u u b b O O u u t t T T e e r r m m i i n n a a l l s s - Connect

subwoofers to these terminals.

(Refer to the Speaker Wiring

Diagrams section of this guide.)

3. S S t t a a t t u u s s L L E E D D s s - The Power LED will

light GREEN to indicate the amplifier

is on and operating normally. The

GREEN LED will turn off and the

Protection LED will light RED when

the amplifier has shut itself down

due to speaker short circuit, DC

offset, or overheating.

4. ( ( + + ) ) 1 1 2 2 V V o o l l t t P P o o w w e e r r - Connect this

terminal through a FUSE or CIRCUIT

BREAKER to the positive terminal of

the vehicle battery or the positive

terminal of an isolated audio

system battery.

W W A A R R N N I I N N G G : : Always protect this power wire by installing a fuse

or circuit breaker of the appropriate size within 12

inches of the battery terminal connection.

5. G G r r o o u u n n d d - Connect these terminals

directly to the sheet metal chassis

of the vehicle, using the shortest

wire necessary to make this

connection. Always use wire of the

same gauge or larger than the

(+)12 volt power wire. The chassis

connection point should be scraped

free of paint and dirt. Use only

quality crimped and/or soldered

connectors at both ends of this

wire. DO NOT connect this terminal

directly to the vehicle battery

ground terminal or any other

factory ground points.