Directed Electronics D600 Instrukcja obsługi - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz samochodowy Directed Electronics D600. Directed Electronics D600 20 stron. Dei orion d600: user guide

Drukuj stronę

NOTE:

The wiring connections to the power, remote and speaker terminals should be

accomplished before the amplifier is mounted.

NOTE:

Mounting amplifiers upside down is not recommended and may cause premature

thermal shutdown.

WARNING!

Do not mount any amplifier in the engine compartment. Amplifiers are not

designed to endure the harsh environment of the exterior elements.

Passenger Compartment

If you are going to mount the amplifier in the passenger compartment, make sure you have

adequate room for ventilation. The amplifiers have been designed to make under-seat

mounting possible. When mounting your amplifier under a seat or similar area, keep a min-

imum of 1" of clearance around the amplifier for adequate cooling.

Trunk Compartment

Mounting your amplifier in the trunk provides excellent performance as long as you do not

restrict the airflow around the heatsink of the amplifier. For optimal results, mount the

amplifier with as much clearance as possible. This type of mounting will yield the best cool-

ing due to the convection effect of the amplifier chassis.

General Precautions and Installation Tips

WARNING!

Be careful not to cut or drill into gas tanks, fuel lines, brake lines, hydraulic

lines, vacuum lines, or electrical wiring when working on your vehicle.

Disconnect the vehicle's ground wire at the battery before making or breaking connections

to the audio system's power supply terminals.

WARNING!

Do not use this amplifier unmounted. Failing to securely mount the amplifi-

er can result in damage or injury, particularly in the event of an accident. An

unmounted amplifier becomes a dangerous projectile in the event of a crash.

Never mount the amplifier where it might get wet. Mount the amplifier so

the wire connections will not be pulled. Route the wires where they will not

be scraped, pinched or damaged in any fashion.

The +12V power supply wire must be fused as close as possible to the battery terminal, ide-

ally within 12". Use the recommended fuse size or circuit breaker listed in the Power

Connections section of this manual.

If you need to replace the fuse plugged into the side of the amplifier, replace the fuse with

the same size ATC type fuse that came with the amplifier. If you are not sure as to the correct

value, refer to the Power Connections section of this manual for details. Using a higher cur-

rent fuse may result in damage to the amplifier that is not covered under warranty.

NOTE:

Make sure all the equipment in the system is turned off when making or break-

ing connections to the input RCAs or speaker terminals. Turn on the system and

slowly turn up the volume control only after double checking all wire connections.

Power for systems with a single amplifier can be supplied by most automotive electrical sys-

tems. Systems with multiple amplifiers may require a higher capacity battery, alternator or

the use of a storage capacitor. We strongly recommend the use of a Directed Audio

Essentials power capacitor with an extra battery in larger stereo systems.