Clarke Contractor CON185 Instrukcja obsługi i konserwacji - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Piła Clarke Contractor CON185. Clarke Contractor CON185 17 stron. 185mm circular saw with laser guide
Drukuj stronę
MOUNTING AND USING THE PARALLEL GUIDE
MOUNTING
1. Slide the parallel guide into the
base plate as shown.
2. Secure in place using the parallel
guide locking screw.
ADJUSTING
1. Loosen the Parallel Guide Locking
Screw.
2. Adjust the Parallel Guide to the
required length.
• There is a scale on the parallel guide that can be used to give an
approximate guide. Always double check using an accurate ruler.
3. Tighten the Parallel Guide Locking Screw to secure the parallel guide in
position.
DUST EXTRACTION
The circular saw can be connected
to a dust extraction system, using a
suitable hose adaptor (not supplied).
• The internal diameter of the
dust extraction outlet is 30 mm.
THE LASER GUIDE
Your saw is fitted with a laser guide to assist with accurate cutting.
SWITCHING ON/OFF
Switch the laser on/off using the on/
off switch.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
10