Clarke WOODWORKER CBS250 Instrukcja obsługi i konserwacji - Strona 13
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Piła Clarke WOODWORKER CBS250. Clarke WOODWORKER CBS250 20 stron. 45 mm (10”) bandsaw & stand
Również dla Clarke WOODWORKER CBS250: Instrukcja obsługi i konserwacji (13 strony)
Drukuj stronę
Lower Blade Wheel
Under normal circumstances, the bottom blade wheel does
not need adjusting, it is factory set and should never alter.
If however the blade tracks off centre and all the previous
adjustments have been carried out correctly, proceed to
adjust as detailed below.
The bottom blade wheel is adjustable in four planes, therefore
caution should be used when making adjustments. It should
only ever be necessary to make changes on the two vertical
adjusting screws shown at 'A' Fig. 15.
To carry out this adjustment,
proceed as follows.
•
Undo both locknuts on
adjusting screws 'A'.
•
Slowly rotate the upper blade
wheel in a clockwise direction,
observing the sawblade whilst
doing so.
•
Undo the top screw 'A1',
approx one flat. and tighten
the bottom screw 'A2' similarly.
If the sawblade tracks in the
desired direction, continue
with the adjustment, if not,
undo the bottom screw and
tighten the top screw.
Continue to make further adjustments in the same way until the blade runs in the centre
of both blade wheels.
When satisfied, check the tracking on the upper wheel. Having completed the lower
wheel adjustment it may be necessary to readjust the upper wheel.
Blade Guide Adjustment
•
Remove the width of cut indicator from the front of the table.
•
Remove the table.
•
Slacken all guides, upper and lower and back them off clear of the blade.
•
Rotate the upper blade wheel and observe the blade again, if the blade now runs
in the centre of the blade wheels, continue to adjust the blade guides. If not adjust
the tracking.
•
With the tracking correct, proceed as follows.
13
'A'
Fig.15
Fig.16