Clarke 6926011 Instrukcja obsługi i konserwacji - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Grzałka Clarke 6926011. Clarke 6926011 13 stron. Halogen heaters
Drukuj stronę
1. Remove the two pozidrive screws securing the wire guard, remove the
guard and store removed parts safely.
2. To remove the halogen tube, grasp and gently but firmly push it to one end
of the heater. The tube holders are spring loaded which will allow the tube
sufficient movement to clear the opposite holder.
3. Remove the halogen tube and dispose of it according to local regulations.
4. Fit new halogen tubes in reverse order, repeat the procedure for the
second tube.
5. Replace the guard using the screws removed earlier.
The heater is now ready for use.
FAULT FINDING
SYMPTOM
Heater does not
operate, although
plugged in and
switched on.
Halogen tube is glow-
ing hot.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
PROBLEM
Plug is loose/bad
connection.
Fuse blown.
No power at socket
outlet.
Tilt safety switch is
disabling unit.
Input voltage incorrect. Ensure power supply
Air inlet partly blocked. Ensure the heater is kept
8
SOLUTION
Remove the plug & check
the connection of the plug
and socket.
Replace if necessary and
investigate the cause. If
fuse blow repeatedly,
consult your Clarke dealer.
Insert plug into a suitable
socket.
Ensure unit is upright. If
switch does not re-set,
consult your Clarke dealer.
matches the rating on the
label.
away from any objects or
materials which could
partially cover the guard or
be drawn onto it.