Clarke CFC100 Instrukcja obsługi i konserwacji - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Narzędzia Clarke CFC100. Clarke CFC100 6 stron. Folding crane
Również dla Clarke CFC100: Instrukcja obsługi i konserwacji (13 strony)
Drukuj stronę
It is not intended for the crane to be manoeuvred around the workshop
in the storage position. However, if the crane MUST be moved this way,
exercise extreme caution with regard to its stability
PREPARING FOR USE
1.
Unfold the legs if necessary by reversing the procedure in paras, 11 and 12
on page 5.
2.
With legs unfolded, release the base stabilising foot by unscrewing and re
moving its retaining bolt and rotating it upwards until the bolt can be
relocated, locking it in that position.
3.
Select the required Jib Arm Length according to the load to be lifted.
Note: Use the shortest jib length possible to give the greatest safety margin
and extra stability.
OPERATION
1.
When removing an engine ensure the vehicle is well supported and se
cure. All ancillary parts must be disconnected, i.e. exhaust system, speedo
cable, electrics etc., and only lifting points recommended by the vehicle
manufacturer should be used.
2.
To raise the jib, first locate the slotted end of the pump handle on to the
Hydraulic Pressure Release Nut at the base of the Ram assembly.
Turn the nut clockwise until tight (DO NOT OVERTIGHTEN a firm pressure
only is required), remove the handle and locate it in the pump collar. Pump
the ram to raise the jib to the required height.
3.
To lower the jib arm, locate the slotted end of the pump handle on to the
pressure release nut and VERY SLOWLY turn in an anticlockwise direction.
The jib will lower under its own weight. The more the handle is turned...the
faster the rate of descent.
EXERCISE GREAT CARE WHEN LOWERING HEAVY LOADS.
Warning
6
MAINTENANCE
Before Use
Always inspect the crane for visible signs of damage, leaking hydraulic fluid, loose,
worn, missing or broken parts etc.
Note:
If the crane is subjected to any abnormal load or shock, it should be removed
from service immediately and inspected by a local agent or Clarke International
Service Division.
Daily
a)
check for tightness of all bolts, and pivoting joints for wear.
b)
lubricate wheels and bearings and inspect for cracks or other possible
damage.
c)
inspect the hydraulic ram assembly for leaks and wipe with oily rag to
prevent corrosion.
Storage
When not in use, store the crane with the jib in its lowest position so there is no load
on the ram and to prevent corrosion of the ram.
To fill The Hydraulic Pump
With the ram fully retracted (in lowered position), remove vent plug (43), on side
of cylinder (it may be necessary to disconnect ram from jib to access plug.
Top up to level of hole with Clarke hydraulic oil (pt. no. 3050830). Replace the
plug and refit jib as described in the assembly instructions.
SPARE PARTS AND SERVICING
Please contact your nearest dealer, or
CLARKE International, on one of the following numbers.
PARTS & SERVICE TEL: 020 8988 7400
PARTS & SERVICE FAX 020 8558 3622
or e-mail as follows:
PARTS: [email protected]
SERVICE: [email protected]
7