Lenovo ThinkAgile MX3321-H Podręcznik użytkownika - Strona 10

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Serwer Lenovo ThinkAgile MX3321-H. Lenovo ThinkAgile MX3321-H 34 stron.

Set the network connection for the Lenovo XClarity Controller

Before you can access the Lenovo XClarity Controller over your network, you must specify how Lenovo

XClarity Controller will connect to the network. Depending on how the network connection is implemented,

you may need to specify a static IP address as well.

The following methods are available to set the network connection for the Lenovo XClarity Controller if you

are not using DHCP:

• If a monitor is attached to the server, you can use Lenovo XClarity Controller to set the network

connection.

• If no monitor is attached to the server, you can set the network connection through the Lenovo XClarity

Controller interface. Connect an Ethernet cable from your laptop to Lenovo XClarity Controller connector,

which is at the rear of the server. For the location of the Lenovo XClarity Controller connector, see the rear

view of the node.

Note: Make sure that you modify the IP settings on the laptop so that it is on the same network as the

server default settings.

The default IPv4 address and the IPv6 Link Local Address (LLA) is provided on the Lenovo XClarity

Controller Network Access label that is affixed to the Pull Out Information Tab.

• If you are using the Lenovo XClarity Administrator Mobile app from a mobile device, you can connect to

the Lenovo XClarity Controller through the Lenovo XClarity Controller USB connector on the front of the

server. For the location of the Lenovo XClarity Controller USB connector, see the front view of the node.

Note: The Lenovo XClarity Controller USB connector mode must be set to manage the Lenovo XClarity

Controller (instead of normal USB mode). To switch from normal mode to Lenovo XClarity Controller

management mode, hold the blue ID button on the front panel for at least 3 seconds until its LED flashes

slowly (once every couple of seconds).

To connect using the Lenovo XClarity Administrator Mobile app:

1. Connect the USB cable of your mobile device to the Lenovo XClarity Administrator USB connector on

the front panel.

2. On your mobile device, enable USB tethering.

3. On your mobile device, launch the Lenovo XClarity Administrator mobile app.

4. If automatic discovery is disabled, click Discovery on the USB Discovery page to connect to the

Lenovo XClarity Controller.

For more information about using the Lenovo XClarity Administrator Mobile app, see:

http://sysmgt.lenovofiles.com/help/index.jsp?topic=%2Fcom.lenovo.lxca.doc%2Flxca_usemobileapp.html

Important: The Lenovo XClarity Controller is set initially with a user name of USERID and password of

PASSW0RD (with a zero, not the letter O). This default user setting has Supervisor access. Change this user

name and password during your initial configuration for enhanced security.

To connect the Lenovo XClarity Controller to the network using the Lenovo XClarity Provisioning Manager,

complete the following steps.

Step 1.

Start the server.

Step 2.

When you see <F1> Setup, press the F1 key.

Step 3.

Specify how the Lenovo XClarity Controller will connect to the network.

• If you choose a static IP connection, make sure that you specify an IPv4 or IPv6 address that is

available on the network.

ThinkAgile MX Certified Node 1UThinkAgile MX3321-H, MX3321-FUser Guide