Lenovo 10w Podręcznik użytkownika - Strona 23

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Tablet Lenovo 10w. Lenovo 10w 38 stron.

Chapter 4. Configure advanced settings

UEFI BIOS setup utility is the first program that the tablet runs. When the tablet turns on, UEFI BIOS setup

utility performs a self test to make sure that various devices in the tablet are functioning.

Restart the tablet. When the logo screen is displayed, press Fn + F2 to enter the UEFI BIOS setup utility.

You might need to change the startup sequence to allow the tablet to start from another device or a network

location.

1. Enter the setup utility.

2. Navigate to the Boot menu.

3. Follow the on-screen instructions to change the order of devices under Boot Priority Order.

Note: You can also change the startup sequence temporarily without opening the setup utility. To do so,

start the tablet. When the logo screen is displayed, press Fn + F12.

1. Open the setup utility.

2. Select Configuration ➙ Hotkey Mode and press Enter.

3. Change the setting to Disabled or Enabled.

4. Select Exit ➙ Exit Saving Changes.

For tablet models with the Always On USB connector, the always-on function can be enabled or disabled in

the setup utility.

1. Open the setup utility.

2. Select Configuration ➙ Always On USB and press Enter.

3. Change the setting to Disabled or Enabled.

4. Select Exit ➙ Exit Saving Changes.

This section introduces the types of passwords that you can set in the setup utility.

You can set various types of passwords in the UEFI BIOS setup utility.

Notes:

• All passwords set in the setup utility consist of alphanumeric characters only.

• If you start the setup utility using the user password, you can only change a few settings.