Nikon N50 Skrócona instrukcja obsługi

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Aparat cyfrowy Nikon N50. Nikon N50 2 stron. Nikon camcorder user manual
Również dla Nikon N50: Arkusz instrukcji (2 strony)

Drukuj stronę

WHILE YOU'RE TAKING PICTURES

Using the Built-In Flash

The flash can be used

when the subject is within

0.6 to 3m (2.0 to 9.8 feet)

when using a film with

ISO 100 and the AF

Zoom-Nikkor 35-80mm

f/4-f/5.6 D lens.

If 4 blinks inside the viewfinder, use the built-in flash. Press the flash

lock release button. Lightly press the shutter release button, wait for the

4 to come on in the viewfinder. Confirm the • (in-focus indicator)

appears in the viewfinder, then fully depress the shutter release button.

• If 4 blinks after shooting for a few seconds, this means that the light

might be insufficient. Check shooting distance, and if necessary,

move closer to subject and take a picture with flash again.

If a stationary

subject starts to

move

Remove your finger from

the shutter release

button and lightly press

again to restart

autofocus.

Viewfinder information

hi I blinks—Overexposure

possible

Use a film with lower ISO, or

use a Nikon Neutral Density

Filter.

Lo blinks—Underexposure

possible

Use the built-in flash.

4 blinks (without flash)—

-1,_" Flash recommendation

This happens when it's dark.

Use the built-in flash.

[ ] blinks inside viewfinder—

Picture blur is possible

The light is probably dim and the

automatically selected shutter speed is

slow. This can cause picture blur due

to camera shake. Hold the camera

steady, or use a tripod. Or, use a built-

in flash.

• blinks—Unacceptable condition

for autofocus

Autofocus requires that the subject

have some contrast or details to focus

upon. Make sure the subject conforms.

You can't focus on the sky, a blank

wall, a very shiny surface, a subject

which has no details or contrast.

WHEN YOU'VE TAKEN A COMPLETE ROLL

Auto Rewind

When the film reaches the end of roll, it rewinds auto¬

matically. After rewinding is completed, remove the film.

•When battery power is very weak, or when temperature is

very low, film may not rewind at the end of roll;

Err

will appear

in the LCD panel. In this case, replace battery with a fresh

one, or wait for the temperature to rise and then press the

rewind button.

To rewind film at mid-roll: Press the

rewind button on the camera bottom.

Shortcut to Great Pictures

Nikon

N50 SHOOTING IN SIMPLE MODE

Read this Instruction Sheet to learn

operate your N50, please also read the

how to use your N50 camera in the

N50 Instruction Manual booklet, after

SIMPLE mode.

you have become familiar with the

For additional information about how to

SIMPLE mode.

Make sure the power switch is turned

Q Insert 6-volt lithium battery pack (2CR5

off. Attach the AF Nikkor lens.

or Duracell DL245 type).

Turn on the power switch and load film.

mark and close the camera back. Film auto-

Pull the film leader out to the red index

matically advances to frame #1.