Nikon DS-Ri1 Instrukcja obsługi - Strona 19

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria do kamer Nikon DS-Ri1. Nikon DS-Ri1 49 stron. Ds camera control unit/camera heads
Również dla Nikon DS-Ri1: Instrukcja obsługi (49 strony)

Drukuj stronę
Nikon DS-Ri1 Instrukcja obsługi

Installing the DS-U3

2
The DS-U3 can be installed horizontally or vertically.
• Horizontal installation
Set the DS-U3 horizontally on a flat surface.
Provide a clearance of approximately 100 mm around the product to release heat.
• Vertical installation
Attach the vertical stand to the DS-U3 for setting the product in the vertical position.
Set the DS-U3 vertically on a flat surface as shown below.
Provide a clearance of approximately 100 mm around the product to release heat.
Attach the vertical stand as follows:
Remove two of the four screws at the upper front position and the lower rear position on the right
side of the DS-U3. (See Figure A below.)
Then, fix the stand to the right surface of the DS-U3 using the screws that have been removed.
(See Figure B below.)
Use an M2.5-size Phillips driver to attach or remove screws.
Chapter 4
Connecting and Installing the Equipment
2
Installing the DS-U3
Figure A
- 11 -
Figure B