Nikon Eclipse 800 Instrukcja instalacji - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Mikroskop Nikon Eclipse 800. Nikon Eclipse 800 9 stron. Motor drive

Last update: 2021/09/23 17:15

microscope so that the edge of the black base plate is against the side of the microscope. Once the

drive is completely pushed onto the microscope reattach the base clamp that you remove in step #2,

and use the 2.5mm Allen Wrench to tighten the set screw in the base clamp assembly. This will cause

the silver press bar to squeeze against the side of the microscope and hold the drive assembly

securely in place. After the base plate has been secured insure that the gears are properly aligned

and that nothing is binding or rubbing.

Step 4 -Aligning the drive

Turn the left ﬁne focus knob and insure that there is no one spot with in the 360 degrees of rotation

where any drag is felt. If you feel any drag, slightly move the drive along the horizontal ( y axis ) and

vertical ( z axis ) to a point where no drag is felt. Since the drive is usually self aligning little or no

movement in the x and y axis is required. Use the 2.5mm and 7/64" Allen wrenches to tighten the

adjustment screws, that were loosened in step # 2, at a point where no drag is felt. Recheck for

minimum drag on the ﬁne focus shaft by turning the right ﬁne focus shaft. Repeat alignment

procedure if necessary.

Step 5 - Installing the cover & Fine Focus knob

Locate the ASI cover. Place it in position over the motor drive assembly and secure it with the screws

provided. Place the new right ﬁne focus knob over the protruding end of the drive shaft and secure it

in place with the two setscrews in the knob.

This completes the installation of the ASI motor drive onto the Nikon Eclipse 800 microscope.

Connecting the Motor Drive to the Controller and Computer

Please refer to the wiring drawings and diagrams given in the manual

Tools Needed:

Small slotted screwdriver

1) Locate the drive cable. Connect one end of the drive cable to the 9 pin connector on the ASI drive

that is attached to the microscope and the other end to mating connector on the back of the

Controller labeled "Drive.

2) Locate the computer interconnect cable. Connect one end to the mating connector on the back of

the Controller labeled "Serial In". Connect the other end to the appropriate serial output of your

computer. For an IBM compatible PC this is typically COM1 through

3) Plug in the MFC-2000 power cord.

This completes the steps necessary to interconnect the ASI motor drive. Please refer to the operation

section of the manual before using the MFC-2000 or MS-2000 controller.

https://asiimaging.com/docs/

nikon_eclipse_800_zdrive https://asiimaging.com/docs/nikon_eclipse_800_zdrive

Printed on 2022/01/12 17:32