Nikon Eclipse E400 POL Instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Mikroskop Nikon Eclipse E400 POL. Nikon Eclipse E400 POL 41 stron. Polarizing microscope
Również dla Nikon Eclipse E400 POL: Instrukcja obsługi (45 strony), Instrukcja obsługi (44 strony)
Drukuj stronę
YANI
1. Intended product use
This microscope should only be used for microscopic observation. Do not
use it for any
other purpose.
2. Do not disassemble
Disassembling may cause malfunction and/or electrical shock. Do not disassemble
any
parts other than those mentioned in this manual. If you notice any malfunction,
notify your
nearest Nikon representative.
3. Input voltage
Make sure that the input voltage indicated on
the back panel of the microscope is the same
as your regional voltage. If not the same, do
not use the microscope; instead, notify your
nearest Nikon representative immediately. If
the microscope is used with the wrong input
voltage, a short circuit or fire may result,
causing the damage of the microscope.
4. Power cord
To prevent electrical shock, always tum off
the power switch (flip it to the "O" side)
before connecting or disconnecting the power
cord. Use only the following power supply
cord set. Using the wrong power cord could
result in damage or fire.
* For 100-120V area
UL Listed, detachable cord set, 3 conductor
grounding type SVT, No. 18 AWG rated at
125V, 7A minimum.
In case of using the extension cord, use only the power supply cord with the
PE (protective
earth) wire.
* For 220-240V area
3 pole power supply cord set, which must be approved according to EU/EN
standards.
_
Class I equipment should be connected to PE (protective earth) terminal.
In case of using the extension cord, use only the power supply cord with the PE
(protective
earth) wire.