Dirtblaster NE445 Instrukcja montażu - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Odkurzacz basenowy Dirtblaster NE445. Dirtblaster NE445 8 stron.

Drukuj stronę

S T T

T E E

E P P

P 4 4

ASSEMBLE THE HOSE

S S

Your cleaner hose comes in 3' sections which

must be connected together. The hoses are

connected by inserting the male cuff of one

section of hose into the female cuff of another.

Twist the sections of hose together until you

establish a snug fit (See figure 5). You will need

to assemble enough sections of hose to reach

from where the cleaner connects to your

skimmer to the opposite end of the pool, plus one

section. For example, if you have a 21' round

pool, you will need to connect 8 sections of hose

for a total of 24' of hose.

NOTE

One of the hose sections has 2 female ends.

This section should be fitted last and will attach

to the pool's vacuum connection. Save extra

sections of hose for replacements.

INSTALL AUTOMATIC

S T T

T E E

E P P

P 5 5

S S

REGULATOR VALVE

This is done by simply attaching the valve to

the last section of hose. The advantage of using

the valve is that it balances the flow of water

between the skimmer and the cleaner. The

valve is strongly recommended for maximum

performance, however is only necessary in

instances where there is excessive pump flow.

Excessive suction will make the cleaner move

too fast and could damage the vacuum's

components and/or decrease the cleaner's ability

to navigate the pool. In these instances the

automatic regulator valve must be used. This

will help restrict flow of water and make the

cleaner operate more efficiently.

NOTE

Automatic Regulator Valve must be installed

so the bypass port is always facing down and is

below the water level.

S T T

T E E

E P P

P 6 6

INSTALL EYEBALL DIVERTER

S S

To install the eyeball diverter remove the

original eyeball from the return by unscrewing the

lock ring. Replace the original eyeball with the

cleaner eyeball diverter. Replace the lock ring

and tighten. The best way to position the eyeball

diverter is so the flow is directed downward.

This will help eliminate the return flow from

interfering with the cleaner.

Figure 5

Flow Control Valve

Suction Bypass Port

Figure 6

Eyeball Diverter

Eyeball Fitting

Eyeball Diverter

Lock (Retaining) Ring

Male End Of Hose

Figure 7