Classen HTS-20H Instrukcja obsługi - Strona 14
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Siewniki Classen HTS-20H. Classen HTS-20H 18 stron.
Drukuj stronę
TROUBLESHOOTING
PROBLEM
A.
Engine will not start.
B.
Loss of power, hard starting.
C. Engine will not idle properly.
D. Engine runs hot or overheats.
14
14
TROUBLESHOOTING GUIDE
POSSIBLE CAUSE
1.
Out of gasoline.
2.
Spark plug lead wire loose or
disconnected.
3.
Defective spark plug.
4.
Throttle control lever not in proper
position.
5.
Engine flooded or flooding.
6.
Stale or contaminated
gasoline.
7.
Engine switch off.
8.
Oil level low.
9. Front cover is loose on unit.
1.
Spark plug lead wire loose.
2.
Defective spark plug.
3.
Carburetor out of adjustment.
4.
Air cleaner dirty.
5.
Air vents clogged or plugged.
1.
Idle speed too slow.
2.
Spark plug gap incorrect.
3.
Air cleaner dirty.
1.
Oil level low.
2.
Engine cooling fins or baffles
clogged with dirt and debris.
3.
Carburetor out of adjustment
HTS-20
CORRECTIVE ACTION
1.
Fill gasoline tank.
2.
Reconnect spark plug lead wire.
3.
Replace spark plug.
4.
Move throttle control lever to start
position.
5.
Start engine with choke fully open.
6
Drain, clean tank and system and
refill with fresh gasoline.
7.
Turn engine switch to ON position.
8.
Fill crankcase to proper oil level.
9.
Make sure front cover is secured
properly on unit.
1.
Tighten spark plug lead wire.
2.
Replace spark plug.
3.
Properly adjust carburetor.
4.
Clean and service air cleaner.
(See the engine Operation and
Maintenance illustrations.)
5.
Clean vent in gasoline tank cap and
carburetor
1.
Adjust carburetor idle speed or idle
mixture.
2.
Set spark plug gap; see your
Engine Manual
3.
Clean and service air cleaner.
(See the engine Operation and
Maintenance illustrations.)
1.
Fill crankcase to proper oil level.
2.
Clean and remove obstructions.
3.
Readjust carburetor.