Dirty hand 101172 Instrukcja obsługi - Strona 14
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przenośny generator Dirty hand 101172. Dirty hand 101172 20 stron. 800 rated watts/900 maximum watts portable power generator
Drukuj stronęMaintenance
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL STARTING TURN THE POWER
SWITCH OF THE ENGINE TO ITS "OFF"
Wait for the engine to cool, and remove the spark plug wire
before performing any inspection, maintenance, or cleaning
Changing /Cleaning the Air Filter
1. Wipe off the air cleaner cover. Then remove two screws that
secure the cover to the generator body (see Figure 6).
2. Remove the air filter.
3. Wash the air filter in warm water and mild detergent
several times. Rinse. Squeeze out excess water and allow it
to dry completely. Soak the filter in lightweight oil briefly,
then squeeze out the excess oil.
4. Install a new air filter or reinstall the cleaned air filter.
Secure the air cleaner cover before use.
Spark Plug Maintenance:
1. Disconnect spark plug wire from end of plug. Clean out
debris from around the spark plug.
2. Using the spark plug wrench provided, remove the spark
plug. Inspect the spark plug. If the electrode is oily, clean
it using a clean, dry rag. If the electrode has deposits on it,
polish it using emery paper. If the white insulator is cracked
or chipped, replace the spark plug.
3. When installing a new spark plug, adjust the plug's gap to
the specification on the technical specification chart. Do not
pry against the electrode or the insulator, the spark plug can
be damaged. (See Figure 7.)
4. Install the new spark plug or the cleaned spark plug into the
engine. Gasket style spark plugs should be finger-tightened
until the gasket contacts the cylinder head, then turned
about 1/2 to 2/3 more rotation. Non-gasket-style spark
plugs should be finger-tightened until the plug contacts the
head, then about 1/16 turn more.
14
!
WARNING
POSITION.
procedures.
AIR
FILTER
AIR FILTER
COVER
Figure 6
Figure 7