Dirty Hand Tools 104306 Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt do trawników i ogrodów Dirty Hand Tools 104306. Dirty Hand Tools 104306 12 stron. Hand held post hole digger

Drukuj stronę

HEX CAP

SCREWS

REPLACEABLE

CUTTING

PROBLEM

Engine will not start

Engine runs rough, oods during operation

Engine is hard to start

Engine misses or lacks power

Auger turns when engine idles

Auger jumps when drilling

Maintenance

ALWAYS PERFORM MAINTENANCE OPERATIONS

THE SPARK PLUG WIRE DETACHED, AND THE

Replace the cutting blade on the auger when it shows excessive

wear or it is unusually diﬃcult to drill holes. To remove the cutting

blade from the auger, remove the two 1/2 in. hex cap screws.

cutting blade can be replaced with a new blade or it can sharpened

with a ﬁle, then replaced.

Check the oil level after every 50 hours of operation. Use EP90

lubricant or equivalent and ﬁll to oil level plug. Always use the

EDGE

same replacement lubricant type.

Troubleshooting

WARNING

WITH THE ENGINE POWERED OFF,

AUGER TIP RESTING ON THE GROUND

• Add fuel to fuel tank.

• Connect spark plug wire to spark plug

• Choke should be at start position for a cold start

• Engine On/O switch is OFF

• Clean or replace air cleaner

• Drain old fuel and replace with fresh. Make sure the

2-cycle oil to gas mixture is correct.

• Make sure spark plug wire is securely attached

• Trigger safety control must be released

• Choke is not in proper start position

• Remove and clean fuel tank

• Clean or replace air cleaner

• Improper carburetor adjustment, take to authorized

engine service center

• Replace spark plug and adjust gap

• Drain and re ll gas tank and carburetor

• Idle speed too high

• Cutting edge needs to be sharpened or replaced

SOLUTION