DIRTY HANDS 104609 Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przenośny generator DIRTY HANDS 104609. DIRTY HANDS 104609 20 stron.

Operation

Starting the Generator

1. Remove all connected devices.

2. Open the fuel tank air vent to the "OPEN" position.

3. Turn the fuel On/Off lever to the "ON" position.

4. Turn the engine switch to the "ON" position

5. Press the primer bulb 5 - 6 times.

6. Turn the choke lever to the "CHOKE" position when starting

a cold engine.

7. Grasp the carrying handle firmly to prevent the generator

from falling over when pulling the recoil starter. Pull the

recoil starter handle slowly until resistance is felt.Return the

handle to its original position and pull swiftly. Do allow the

rope recoil handle to snap back into position. After the engine

starts, allow the starter handle to return to its original position.

8. Allow the engine to run and warm up, then turn the choke

lever back to the "RUN" position.

9. Allow the generator to run for several minutes before

connecting electronic devices. minutes.

ONLY AFTER THE GENERATOR IS RUNNING

SMOOTHLY SHOULD AN APPLIANCE OR TOOL

BE PLUGGED INTO THE AC OUTLET OF THE

Attaching Electronic Devices

1. Check the AC pilot lamp for proper voltage.

2. Turn off the switch(es) of the electrical appliance(s) before

connecting to the generator.

3. Be sure the total load is within generator rated output.

4. The economy control switch must be turned to "OFF" when

using electric devices that require a large starting current, such

as a compressor or a submergible pump.

CAUTION

GENERATOR.