Disaster Area Designs DPC.micro Podręcznik użytkownika - Strona 4

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Przełącznik Disaster Area Designs DPC.micro. Disaster Area Designs DPC.micro 4 stron. Compact programmable effects switcher

Drukuj stronę
c
OnfIguratIOn
The DPC.micro has two configuration modes: MIDI and Display. To enter a configuration
mode, power on the DPC.micro and then hold the relevant button after the LEDs start
flashing.
HOLD
SET BRIGHTNESS
C LED FLASHES
SET POP STOP
FACTORY RESET: Hold both the A and C buttons at power on to clear all preset data and configuration.
The factory default settings are MIDI channel 16, Chain ID 0, Pop reduction OFF, RED / GREEN / BLUE LEDs,
Brightness 4.
MIdI c
OntrOl
There are three ways to control the DPC.micro using MIDI.
The simplest way is to send a program change ranging from 120 to 127. Each program change corresponds
to a different unique loop setting, and will never change.
120: No loops active
121: A active
122: B active
123: A & B active
You can also save your own loop combinations to the internal memory of the DPC.micro, and load them
using MIDI program changes 0-119.
Send a MIDI program change from your controller on the DPC.micro's MIDI channel. The DPC will load the
contents of its memory. To edit, use the Loop mode on the DPC.micro to change the loop assignments and
then hold the C (SAVE) footswitch. The DPC.micro will save the new data in the current memory location.
The final way to control the DPC.micro is to send MIDI CC messages. MIDI CC 50, 51, and 52 control the A,
B, and C loops respectively. Send a value from 0-63 to turn the loop OFF, or a value from 64-127 to turn the
loop ON.
If more than one DPC.micro is used in the same system, you can use the MIDI Chain ID function in the DPC
setup to move the range of the MIDI CC values. This allows up to four DPC.micro to share the same MIDI
channel and still have each loop be individually accessible from your MIDI controller.
Chain ID
Loop A CC
Loop B CC
Loop C CC
TAP
SET LED COLOR
TAP
SET MIDI CHAIN
124:
125:
126:
127:
0 (RED)
1 (GRN)
50
53
51
54
52
55
DISPLAY CONFIGURATION - HOLD B.
Tap each footswitch to set the LED color used in LOOP MODE.
Hold any footswitch to set the LED Brightness.
Power off to save.
MIDI CONFIGURATION - HOLD C.
Tap footswitch A to set the MIDI Chain ID.
RED = 0,
GREEN = 1,
BLUE = 2,
Tap footswitch B to set the automatic pop reduction.
OFF = disable,
RED = low,
Send a MIDI program change message from your controller to
set the DPC MIDI channel.
Power off to save.
C active
A & C active
B & C active
A & B & C active
2 (BLU)
3 (ORG)
56
59
57
60
58
61
ORANGE = 3.
GREEN = medium,
BLUE = high.