Aercus WS2073 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Stacja pogodowa Aercus WS2073. Aercus WS2073 16 stron. Professional wireless weather station

temperature signal, you will need to follow the battery installation procedure again. To perform a proper

reset wait a minimum of 10 seconds after removing the batteries before re-inserting for both the

transmitter and receiver.

Note: If the batteries are changed on the transmitter, the base station will resynchronise with the transmitter

within the following 3 hours. If you want to shorten the time it takes to receive data, you must re-install the

batteries in the base station so the new security code can be learnt right way. However the previous weather

data and alarm value settings in the base station will be lost.

Note: When batteries require replacement in the base station, the low battery indicator will light up on the

LCD.

Please participate in the preservation of the environment by properly disposing of all used batteries at designated

disposal points. Never dispose of batteries in a fire as this may cause an explosion/risk of fire or leakage of

dangerous chemicals and fumes.

3.2 Mounting

The base station

With one foldable leg at the back of the unit the base station can be placed onto any flat surface or

wall mounted using the hanging holes on the back of the unit. It is important to check that outdoor

sensor data can be received before permanently mounting any of the units.

2) The remote sensor

For accurate results, the remote sensor mast should be securely mounted in an open area away from

trees or other coverings where rainfall or wind speed may be reduced causing inaccurate readings.

a) Mounting the wind sensor onto mast

Firstly, check that the wind-fan can rotate freely before fixing the unit. The wind sensor should now

be mounted using the screw and mast provided to allow the wind to travel around the sensor

unhindered from all directions.

Front

b) Mounting the rain sensor

Back