Cub Cadet 221 LHP Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odśnieżarka Cub Cadet 221 LHP. Cub Cadet 221 LHP 20 stron. Single stage snow thrower
Również dla Cub Cadet 221 LHP: Broszura i specyfikacje (2 strony), Instrukcja obsługi (20 strony), Specyfikacje (2 strony), Instrukcja obsługi (20 strony)
Drukuj stronę
Installing the Chute
1.
On the 221 HP model place the chute handle on the lower
chute as shown in Figure 3-4. Skip to step 2 for 221 LHP
models. Be certain that the handle is aligned in the channel
on the chute and the tabs snap into place.
2.
Remove the hex washer screws in the chute base. See
Figure 3-5.
Hex Washer
Screw
8
S
3— A
ection
SSembly
Channel
Tab
Figure 3-4
Figure 3-5
& S
-U
et
p
3.
Align the holes in the chute base with the holes in the
lower chute and secure with the previously removed hex
washer screws. See Figure 3-6.
Figure 3-6
Installing Chute Rotation Control Assembly (Model 221 LHP only)
1.
Remove the four hex washer screws from the back of the
handle (two on each side). See Figure 3-7.
Figure 3-7