Blade NANO QX 3d Podręcznik - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik dla Quadcoptery Blade NANO QX 3d. Blade NANO QX 3d 13 stron.

Transmitter and Receiver Binding

IMPORTANT: Set up your transmitter before binding your transmitter to the aircraft.

Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifier) code of a specific transmitter.

You need to 'bind' your chosen Spektrum

or DSM2

/DSMX

™

operation. If you purchased an RTF model, the transmitter is bound to the model at the factory.

To bind or re-bind your quadcopter to your chosen transmitter, please follow the directions below.

General Binding Procedure

1. Disconnect the flight battery from the quadcopter.

2. Select a clean model memory on your transmitter (computer radios only).

3. Select Acro or Airplane model type on your transmitter.

4. Make sure all servo reversing is set correctly on your transmitter.

5. Center all trims on your transmitter.

6. Power off the transmitter and move all switches to the 0 position. Move the throttle to the low/off position.

7. Connect the flight battery in the quadcopter. The blue LED on the 4-in-1 control unit flashes after 5 seconds.

8. Put the transmitter into bind mode while powering on the transmitter.

9. Release the bind button/switch after 2–3 seconds. The quadcopter is bound when the blue LED on the 4-in-1 control unit turns solid.

10. Disconnect the flight battery and power the transmitter off.

CAUTION: When using a Futaba

transmitter with a Spektrum module, you must reverse the throttle channel and rebind. Refer

to your Spektrum module manual for binding and failsafe instructions. Refer to your Futaba transmitter manual for

instructions on reversing the throttle channel.

technology equipped aircraft transmitter to the receiver for proper

RTF

Your RTF transmitter comes prebound to the model. If you need to re-bind, follow the directions below.

MLP6DSM Binding Procedure

1. Disconnect the flight battery from the quadcopter.

2. Center all trims on your transmitter.

3. Power off the transmitter and move the throttle stick to the down/off position.

4. Connect the flight battery in the quadcopter. The LED on the 4-in-1 control unit flashes after 5 seconds.

5. When the blue light is flashing, push in and hold down the left stick* while powering on the transmitter (you will hear a 'click').

6. Release the left stick. The transmitter will beep and the power LED will blink.

7. The quadcopter is bound when the LED on the 4-in-1 control unit is solid blue (not blinking).

8. Disconnect the flight battery and power the transmitter off.

* The trigger switch may also be used for the binding procedure.

If you encounter problems, obey binding instructions and refer to the troubleshooting guide for other instructions. If needed, contact the

appropriate Horizon Product Support office. For a list of compatible DSM

Technology

Revolutionary SAFE

(Sensor Assisted Flight Envelope) technology uses an innovative combination of multi-axis sensors and software that

allows model aircraft to know its position relative to the horizon. This spatial awareness is utilized to create a controlled flight envelope the

aircraft can use to maintain a safe region of bank and pitch angles so you can fly more safely. Far beyond stability, this level of protection offers

multiple modes so the pilot can choose to develop his or her skills with a greater degree of security and flight control that always feels crisp

and responsive.

SAFE technology delivers:

• Flight envelope protection you can enable at the flip of a switch.

• Multiple modes let you adapt SAFE technology to your skill level instantly.

Best of all, sophisticated SAFE technology doesn't require any work to enjoy. Every aircraft with SAFE installed is ready to use and optimized to

offer the best possible flight experience.

FlySAFERC.com

transmitters, please visit www.bindnfly.com.