Bladelius GRENDEL Instrukcja obsługi i instalacji - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi i instalacji dla Wzmacniacz Bladelius GRENDEL. Bladelius GRENDEL 9 stron. Multi channel amplifier
Drukuj stronęIf your Grendel amplifier is configured with less than 5 power modules the
unused locations (slots) are covered with cover plates. Additional power
modules can always be added or changed to reconfigure your Grendel to
meet your current requirements.
When viewing Grendel from the front, we recommend that you connect your
front audio system channels beginning at the far left of the amplifier.
Operation
Front-Panel Controls and Indicators:
1. POWER SWITCH
2. Five Status LEDs
1. The front-panel momentary-contact switch will power on, and place the
Grendel into standby. Once you turn on the amplifier via the front-panel
switch, only the front-panel switch can return the amplifier to standby state.
2. The STATUS LEDs flash blue when the amplifier goes into protection
mode. For example, in the unlikely event of overheating, shorting, or DC-
input, protection mode would be activated and the LED will flash for the power
module in fault. The amplifier will stay in this state until the cause of the fault
has been corrected. Turn off the amplifier and check all connections (Please
refer to the section about cooling). Once you have removed the cause of the
fault, turn on the amplifier and it should return to normal operation. If the
Grendel stays in protection mode you might need to replace a fuse or have
the amplifier checked by a qualified service technician. If you have any
questions about the operation of the amplifier we recommend that you consult
your dealer.
Rear-Panel Controls and Connections:
Amplifier modules
1. SPEAKERS Terminal Posts
2. INPUT SWITCH BALANCED/UNBALANCED
3. CHANNEL INPUT UNBALANCED
4. CHANNEL INPUT BALANCED
Chassis
5. COM-port (communication with other Bladelius products)
6. Indicator LEDs
7. RS 232 port (for control and software updates)
3