Classic Car Stereo CR017 Classic 200 Podręcznik użytkownika - Strona 9
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Samochodowy system stereo Classic Car Stereo CR017 Classic 200. Classic Car Stereo CR017 Classic 200 16 stron. Dab dab+ fm rds usb bluetooth hands free & streaming aux in radio
Drukuj stronę
- 1. Table of Contents
- 2. Audio Source Selection
- 3. Dab / Dab
- 4. FM Radio
- 5. Bluetooth Music Streaming
- 6. Bluetooth Hands Free Mobile Phone
- 7. Auxiliary Input
- 8. Usb
- 9. Ipod Mode
- 10. Installation
- 11. Mounting the Radio
- 12. Diagnostics
- 13. Diagnostics
- 14. Wiring Diagram
- 15. Dimensioned Drawing
- 16. Electrical Connections
within the oval cut out in the radio to the appropriate distance apart then re-tighten
the spindle nuts. Please note that you should only loosen the nuts to adjust the
spindle spacing and not as part of the mounting process. The fascia has pre cut holes
for the spindles and would need to be modified for the new spindle spacing. The
spindles can be adjusted from 132 to 150 mm apart.
Fitting the DAB antenna
The antenna should be mounted towards the top of the windscreen and at least 4
centimeters (1 ½ inches) from any metal. It can be mounted vertically or horizontally,
however, please bear in mind that you will need to run the cable from the window
element to the radio.
Once satisfied with the position, thoroughly clean the area of glass in question and
make sure it is dry. It is advisable to warm the area before application in cold or
damp conditions. Remove the brown backing paper from the element and stick the
element to the window. Make sure it stuck to the window correctly by pressing
firmly. Now you can remove the front plastic film then the three plastic sections from
within the element to leave just the element and the surrounding 2mm of plastic film
remaining.
Next, you need to fit the cable/connector to the window ensuring that the gold
prongs are each touching one of the square contacts on the element. You may need
to bend the prongs slightly before removing the red backing film to make sure it
aligns correctly. It does not matter which prong touches with which contact providing
there is one on each.
Now run the cable to the radio aperture and screw the gold connector firmly to
the corresponding connector on the radio marked DAB ant. The red wire should
be connected to the blue wire A5 in the radio ISO connector and the black wire
connected to earth or the black wire A8 in the ISO connector.
Power and speaker connections
ISO Connector A
Wire colour
Black
Red
Yellow
Blue
Pin number
connect to
A8
chassis/earth
A7
+12 volt ignition/accessory
A4
+12 volt permanent power supply
A5
Dab antenna (and FM antenna if
powered/electric.)
Installation
9