3D Fun Printz Universal Pen Holder Skrócona instrukcja obsługi - Strona 2
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Akcesoria 3D Fun Printz Universal Pen Holder. 3D Fun Printz Universal Pen Holder 3 stron.
Drukuj stronę
Unscrew the top cap most of the way but not all the way off the pen holder.
Insert your pen so the nib just touches the alignment clip as below.
While gently holding the pen in place screw the top cap down so the flexible inserts retract
into the holder and grip the pen. The cap does not need to be screwed down hard, just
enough to grip the pen and stop it moving. The first few times you use the pen holder the
cap may be slightly stiff but will ease with use.
Now insert the holder into the machine.
Adjust the draw pressure to 0 before you begin.
DO NOT FORCE THE LATCH DOWN. IT SHOULD BE NO HARDER TO
LATCH THEN WITH ANY OTHER BROTHER ACCESSORY. IF IT IS STIFF
REMOVE THE HOLDER, ADJUST AND REINSERT
When you start to print the machine may tell you that it does not recognise the accessory.
Just press Continue, Ok or Accept and it should start to draw.
You may need to adjust the draw pressure further on your machine to get satisfactory
results.
To remove the pen unscrew the lid most of the way and pull the pen out gently. You may
need to wiggle the pen gently in a circular motion to release the grip mechanism.
When not in use do not leave a pen in the holder and try not to screw the lid all the way
down for storage. This will help to preserve the flexible parts of the holder. If you forget
and find the nibs have deformed then leave the holder without a pen for a few hours and
the nibs will return to their original position.
The holder takes numerous pens from a pencil size to just smaller than a full size sharpie.
Care of your Universal Pen Adapter
Due to the way the grip mechanism works it may require lubricating periodically. If the
mechanism feels stiff or "gritty" when you screw the cap down then it is time for a little
lubrication.