3D Hobby Shop ASPERA ARF 46 Instrukcja montażu - Strona 17

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Zabawka 3D Hobby Shop ASPERA ARF 46. 3D Hobby Shop ASPERA ARF 46 17 stron. Radio controlled aircraft

Drukuj stronę

Balance and Setup

Balance the airplane 4 3/4 inches (117mm) from the leading edge of the wing at the root (where the wing

meets the fuselage). After initial flights, you may want to move the Center of Gravity back to 4 7/8 inches

(120mm) to achieve best inverted performance.

Control Throws:

Measure control throws at the rear edge of the surface.

Low Rate Settings:

Ailerons - 1/2" up and down.

Elevator - 5/8" up and down.

Rudder - 2" Right and Left.

We recommend 30-35% exponential (Positive on JR/Spektrum, Negative on Futaba/Hitec) on all

low rate controls.

High Rate Settings:

Ailerons - 7/8" up and down.

Elevator - 1" up and down.

Rudder - As much as possible, this throw is limited by interference with the elevator on each

side.

We recommend 50-60% exponential (Positive on JR/Spektrum, Negative on Futaba/Hitec) on all high rate

controls.

Install your propeller. Be sure to check the motor manufacturer's recommendations for help in selecting a

prop. Test your power system in a safe manner on the ground before ever attempting to fly your aircraft.

Range check your radio system according to manufacturer's instructions.

During the trimming phase, we recommend landing with some throttle, not attempting to "dead stick" the

airplane. This may mean you need to time your flights and keep them a bit shorter than usual. After your

first flights, check all control connections and motor and prop mounts for tightness.

We hope you enjoy your

Be sure to look for new aircraft coming soon from 3D Hobby Shop!

3 D H O B B Y S H O P . C O M

3D Hobby Shop

Aspera.