3D Hobby Shop EPP EXTRA 330SC Instrukcja montażu - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Zabawka 3D Hobby Shop EPP EXTRA 330SC. 3D Hobby Shop EPP EXTRA 330SC 15 stron. Arf rc

The wings are held on with the provided rubber bands wrapped 2-3 times around the wing hooks.

Plug your servos and ESC into your receiver, attach your battery and test your radio system. Check for

correct motor running direction now, before your prop is installed. Never run your motor inside a

building with the prop installed. Check for correct servo direction, reverse as necessary. Center all

Low/Precision Rates (in degrees and inches) and Corresponding Exponential

•

Aileron 15 degrees .75" 30% Expo

•

Elevator 13 degrees 1.25" 30% Expo

•

Rudder 45 degrees 3.5" 75% Expo

High/3D Rates (in degrees and inches) and Corresponding Exponential

•

Aileron 35 degrees 2" 75% Expo

•

Elevator 45 degrees 3" 75% Expo

•

Rudder 45 degrees 3.5" 75% Expo

The above throw measurements were taken at the aft edge of the ailerons and

elevator, and from the bottom aft edge of the rudder. Keep in mind that even the low throws

mentioned here are relatively aggressive, so be sure to also program the matching

exponential listed to help soften the model's feel around center stick.

Balance your Extra at a point 4.5" behind the leading edge of the wing where the wing meets the fuselage.

This is a good starting point. As you become accustom to the aircraft, you can adjust the CG to suit your preference.

NOTE: Small brushless motors typically have aluminum prop adaptors with aluminum screws threads.

These threads are easily stripped or broken. DO NOT apply too much torque when tightening your

prop. A wrench is not necessary, it applies too much torque. We prefer a nut-driver.

Be sure to check the motor manufacturer's recommendations for help in selecting a prop. Test your

power system in a safe manner on the ground before ever attempting to fly your aircraft. Range check

Make your first flight with the controls set on low rates. During the trimming phase, we recommend

landing with some throttle, not attempting to "dead stick" the airplane. This may mean you need to time

your flights and keep them a bit shorter than usual. After your first flights, check all control connections

control surfaces and tighten pushrod adjusters securely.

Control Throws and Exponential

Install your propeller

your radio system according to manufacturer's instructions.

and motor and prop mounts for tightness.

Balancing