ARO SRB21A-10-H Instrukcja obsługi

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wkrętak sieciowy ARO SRB21A-10-H. ARO SRB21A-10-H 8 stron. 20 series right-angle screwdriver

Drukuj stronę

OPERATOR'S MANUAL

SECTION

M32

MANUAL

INCLUDING: OPERATION, INSTALLATION & MAINTENANCE

Released: 5-13-94

Tool Products

Revised: 11-10-95

20 SERIES RIGHT-ANGLE SCREWDRIVER

Models: SRB21A-( )-( )

WARNING

READ THIS MANUAL CAREFULLY BEFORE INSTALLING,

OPERATING OR SERVICING THIS EQUIPMENT.

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.

Pneumatic tools should always be installed and used in accor-

dance with A.N.S.I. 8186.1 "Safety Code For Portable Air Tools."

Operate this tool at 90 p.s.i.g. (6.2 bar) maximum air pressure

at the air inlet of the tool.

Disconnect air supply from tool before removinq/installing

bit,

socket or device attached to tool or performing maintenance

procedures.

Keep hands, clothing and long hair away from rotating end of

tool.

Anticipate and be alert for sudden changes in motion during

start up and operation of any power tool.

Never exceed rated r.p.m. of tool.

Wear suitable eye and hearing protection while operating tool.

Tool shaft can continue to rotate briefly after throttle is re-

leased.

Do not lubricate tools with flammable orvolatile liquids such as

kerosene, diesel or jet fuel.

Do not remove any labels. Replace any damaged label.

Use only accessories

recommended

by ARO.

Repeated prolonged operator exposure to vibrations which may

be generated

in the use of certain hand-held

tools may produce

Raynaud's

phenomenon,

commonly

referred to as Whitefinger

disease.

The phenomenon

produces

numbness

and burning

sensations in the hand and may cause circulation and nerve dam-

age as well as tissue necrosis.

Repetitive

users of hand-held

tools who experience

vibrations

should closely monitor duration

of use and their physical condition.

The use of other than genuine ARO replacement

parts may

result in safety hazards, decreased

tool performance

and in-

creased maintenance

and may invalidate all warranties.

ARO is not responsible

for customer modification

of tools for

applications

on which ARO was not consulted.

Tool maintenance

and repair should be performed by autho-

rized, trained, competent

personnel.

Consult your nearest

ARO authorized

servicenter.

It is the responsibility

of the employer to place the information

in this manual into the hands of the operator.

For parts and service information, contact your local ARO distributor, or the Customer Service Dept. of the Ingersoll-Rand

Distribution

Center, White House, TN at PH: (615) 672-0321,

FAX: (615) 672-0801.

ARO Tool Products

Ingersoll-Rand

Company

1725 U.S. No. 1 North

P.O. Box 8000

Southern Pines, NC 2838843000

Part of worldwide Ingersoll-Rand