AROFLY ELITE Skrócona instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Akcesoria rowerowe AROFLY ELITE. AROFLY ELITE 11 stron.

INSTALLING AROFLY SENSOR ON CYCLE REAR VALVE ONLY

Tips:

Before installing AROFLY sensor to the rear tire valve, please inﬂate the bike

tires to appropriate tire pressure as marked on the tire. Suggest the road

bike to be 90~120psi (6~8bar); Mountain bike to be 35~65psi (2.4~4.5bar)

Before using AROFLY sensor, twist open the cap, then remove the INSULATION

TAB, from between the battery contact.

Place Wrench onto the AROFLY Base.

Twist counter-clockwise to open

AROFLY Cap.

Installing AROFLY to the cycle rear valve: If it is a Schrader valve, please install

directly; If it is a Presta valve, please use the Presta valve adaptor ﬁrst, included

in the kit, before installing the AROFLY sensor.

If it is a Presta valve, please loosen

"the valve pin" to the top-end of the

Presta valve shaft.

Twist Adaptor firmly on the Presta

valve.

If it is a Schrader valve, AROFLY can

be installed directly onto the rear

valve (no need for any adaptor).

Pull and remove Insulation Tab from

AROFLY to connect battery. Replace

the cap to AROFLY.

Install "Valve Adaptor" on Presta

valve.

E n su re th e c o rre c t si de of t h e

Adaptor to the Valve.

Install AROFLY on the Adaptor.

Be sure to twist tightly to avoid

air leakage, and to ensure good

contact with valve pin.

Insulation Tab