AROHA SM11R4 Skrócona instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Alarm dymowy AROHA SM11R4. AROHA SM11R4 20 stron. Interconnected smoke detector

2. Do not paint your smoke detector.

3. The battery cannot be replaced; do not try to replace the battery.

Activate and deactivate the device

The device is deactivated by default before leaving the factory. Before the

device can be used normally, the product must be activated.

Activate: Press the test button over 10 seconds until the red LED indicator lights

up. After you release the test button the smoke detector is activated and can

be used.

Deactivate: Press the test button over 10 seconds until the red LED indicator

blinks twice. After you release the test button the smoke detector is

deactivated and cannot be used.

How to link the smoke alarms

Step 1: Press the test/silence button on one of the smoke alarms 4 times. The

smoke detector enters transmitting mode for 60sec and the green LED will

rapidly flash.

Step 2: Press the test/silence button on the other smoke alarms twice. The green

LED will slowly flash, indicating receiving mode.

Step 3: If pairing is successful, the green LED on the receiving alarms will stop

flashing. When there is an error the green light will continue to flash for 60

seconds followed by a red light for 2 seconds.

How to unlink a smoke alarm

Press the test/silence button on the smoke alarm twice and the green LED will

slowly flash for 60 seconds (receiving mode). After this period, it will stop

flasing and the smoke alarm is unlinked.

Test your alarm

Test the unit to ensure proper operation by pressing the cover. The alarm will

sound if the unit is working well. If there is no sound, refer to the "Trouble

shooting" section.

CAUTION:

1. DO NOT test your smoke detector using an open flame. This may

damage the smoke alarm or ignite combustible materials and start a

structural fire.

2. DO NOT stand close to the smoke detector when the alarm is sounding.

Exposure at close range may be harmful to your ears.

3. Monthly test: test this smoke detector once a month.

LED Indicators

1. Normal status: Green LED Flashes once every 60 seconds.

2. Test status: Red LED flashes once every second.

3. Hush/Silence mode: Red LED flashes once every 8 seconds.

4. Low battery status: Red LED flashes once every 60 seconds and 1 beep

every 60 seconds.

5. Fault status: the alarm will beep every 40 seconds.

Silence Mode

When the smoke detector is going off you can push the test button to pause it

for approx. 10 minutes. During this silence mode the red LED will flash once