3D Hobby Shop Extra SHP 47" Instrukcja montażu - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Samoloty 3D Hobby Shop Extra SHP 47". 3D Hobby Shop Extra SHP 47" 20 stron. Arf rc

Install tailwheel bracket with two small wood screws. Check for free swinging of rudder. Adjust bracket

as necessary to allow rudder to swing freely. Install tailwheel and tighten tailwheel collar with 1.5mm

allen wrench.

Locate the 4 control horns in your kit. The two on the right are for the elevator and rudder. The longer

horns on the left are for the ailerons.

Remove the covering over the slot in the rudder on the RIGHT side as shown, apply a generous amount

of medium CA into the slot and onto the bottom of the control horn. Insert horn into slot fully as shown

and allow to cure.