Aroma AAF-200 Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Fryer Aroma AAF-200. Aroma AAF-200 4 stron.

Grounding Instructions

This appliance must be grounded while in use to protect the operator from electrical shock. The appliance is equipped with a

3-conductor cord and a 3-prong grounding-type plug to fit the proper grounding-type receptacle. The appliance has a plug

that looks like figure (A).

BEFORE FIRST USE

1. Read all instructions and important safeguards.

2. Remove all packaging materials and check that all

items have been received in good condition.

3. Tear up all plastic bags as they can pose a risk to

children.

4. Remove the baking tray from the frying pan for

easier cleaning.

5. Thoroughly clean the frying pan and baking tray

with soapy water. Rinse and dry thoroughly. Wipe the

surface of the body and inside with a wet cloth.

NOTE:

• You can also wash the removable parts in a dishwasher.

• Always take care not to allow electrical components to come into contact with water.

using air fryer

1. Pull the pan out of the main body of the air fryer. Make sure that the baking tray is inserted and pushed to the bottom.

2. Add your ingredients to the frying pan. Distribute food evenly throughout the pan to ensure even cooking.

3. Slide the pan back into the air fryer.

4. Plug the power cord into an available 120V AC wall outlet.

5. Turn the time control dial to the required cooking time for your recipe. The indicator light will illuminate.

6. The timer bell will ding when cooking is complete and the indicator light will turn off.

7. Pull the pan out of the appliance. Keep your face and hands away from the hot steam when opening. Place the pan on

a heat-resistant surface.

CAUTION:

• Do not touch the pan during and some time after use, as it gets very hot. Only hold the pan by the handle.

• Never use the pan without the baking tray in it. If the appliance is heating ingredients in the absence of the baking tray,

use a special oven glove to open the drawer. The side wall and edge of the drawer can become very hot.

• Do not fill the pan with oil or any other liquid. This is not intended to be used as a deep fryer.

NOTE:

• Do not turn the frying pan upside down as any excess oil that has collected on the bottom of the pan below the baking

tray will leak onto the ingredients.

• When a batch of ingredients is ready, the air fryer is instantly ready for preparing another batch.

HELPFUL HINTS:

• Some ingredients require shaking halfway through the preparation time. To shake the ingredients, pull the pan

out of the appliance by the handle and shake it. Then slide the pan back into the airfryer. If you set the timer to

half the preparation time, you hear the timer bell ding when you have to shake the ingredients. However, this

means that you have to set the timer again to the remaining preparation time after shaking.

• Smaller ingredients usually require a slightly shorter preparation time than larger ingredients.

• A larger amount of ingredients only requires a slightly longer preparation time, a smaller amount of ingredients

only requires a slightly shorter preparation time

• Brush a small amount of oil to fresh potatoes for a crispy result. Fry your ingredients in the air fryer within a few

minutes of adding the oil.

• You can also use the airfryer to reheat ingredients. To reheat ingredients, set the time to 10 minutes.

GROUNDING

PRONG

Figure ( A )

6. Let all parts dry completely. Make sure the rubber scratch

guards of the baking tray are fully covering the metal feet

to avoid scratching the non-stick inner surface of the frying

pan.

7. After cleaning, the unit must be broken in by running for 30

minutes without any food inside. Any smells produced during this

time frame are normal. Please ensure sufficient ventilation of

the room and at least an inch of clearance on all sides of the air

fryer is available. After the breaking in period, rinse and dry all

removable parts. This action is only necessary once before using

for the first time.

CIRCUIT

GROUNDING

CONDUCTOR

CONNECTED

PROPERLY

AAF-200

GROUNDING MEANS

Figure ( B )

AA22D

METAL

MOUNTING

SCREW

COVER OF

GROUNDED

Figure ( C )

OUTLET BOX

ADAPTER