CubuSynth Dual CS-20 VCF Podręcznik budowy - Strona 14
Przeglądaj online lub pobierz pdf Podręcznik budowy dla Syntezator CubuSynth Dual CS-20 VCF. CubuSynth Dual CS-20 VCF 16 stron. Dual / stereo multimode vcf with self-oscillating resonance and intuitive routing and cv modulation matrix
Również dla CubuSynth Dual CS-20 VCF: Podręcznik (9 strony)
Drukuj stronęCubuSynth Dual CS-20 VCF - Build Guide
STEP 18
Installing ICs and final check
4
TL074 / TL084
3
LM13700
Take the Main PCB and install the Ics.
Bend the Legs of the Ics inwards a bit so they form a 90°
degree angle to the body of the chip.
Make sure the orientation is correct, the notch has to
match the silkscreen / the sockets placed before.
Check your soldering. If you see shorts or bad solder joints,
fix it up. Then check the power pins for shorts with your
multimeter.
When everything looks fine, you can connect the two
boards together again, with the three Pin headers
connected properly.
Then tighten the Screw on the Main PCB to the standoffs.
Step 19
Knobs
Place the knobs on the Potentiometers. For best results, turn all
Potentiometers counter-clockwise and push on the knobs, so the
marking points towards the left end of the surrounding circle.
Page 14
U3,U6,U8,U9
U5,U2,U1
PCB V1.4 Mar 2023