Acoustic BPDI Podręcznik użytkownika - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Wzmacniacz Acoustic BPDI. Acoustic BPDI 8 stron. Bass preamp + di

acousticamplification.com

10. Footswitch Jack: Allows connection of a ¼" terminated single button footswitch

(non-included) in order to turn the FX Loop on or off.

11. Input Gain Control With Clip LED Indicator: Adjusts the input level signal gain

of the BPDI while the Clip LED Indicator will illuminate when too much gain

creates preamp clipping (usually undesirable).

12. -10dB Input Pad: Switch reduces input sensitivity for use with active electronics

basses or high output pickups.

13. 4 Band EQ:

Low: This control increases or decreases bass frequencies.

Low Mid: This control increases or decreases low midrange frequencies.

High Mid: This control increases or decreases high midrange frequencies.

High: This control increases or decreases treble frequencies.

Note: At 'noon' setting on the knob there is no boost or cut applied to the

specific frequency band.

14. Acousti-comp™ Button: Activates the built-in compression circuit. When it

is activated the Clip LED will now light to indicate when the signal is being

compressed and will no longer indicate Input Gain Clipping. If you wish to

increase the amount of compression, increase the amount of signal fed into the

compressor by turning up the Gain control till you see activity on the Clip LED.

15 Shape Button: decreases the level of mid frequencies quickly creating an

alternate EQ curve when engaged.

16. Frequency Notch: Control adjusts the notch filter center frequency from 50Hz

(left) to 1kHz (right) creating an EQ notch cut at the desired setting. Note: The

'noon' setting on this knob is the default, but experiment with this powerful tone

shaping control to enhance slap or pop techniques and remove sounds like fret

noise or roll off the high end for a more vintage tone.

17. Volume Control: adjusts the overall volume level of the effected signal output

by the BPDI.

18. Overdrive Controls: Set the amount of overdrive and the blend of the clean

signal with the overdriven signal.

Level: Adjust the amount of overdrive gain being generated by the circuit.

Blend: Controls the mix of the overdriven signal vs clean signal.

19. Overdrive Footswitch: Turns the Overdrive circuit on or off. Note: This control

will engage the overdrive whether or not the Preamp is in Bypass mode, meaning

the BPDI can be used solely as an overdrive pedal if desired.

20. Bypass Footswitch: Disengages the preamp circuit (Gain control, Acousti-

comp™, EQ, Shape, Notch Filer and Volume controls are disengaged) leaving

the signal going through the BPDI unaffected. This functionally turns the BPDI

into a regular DI with no tone shaping applied.