3D Robotics pixhawk Skrócona instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla System autopilota 3D Robotics pixhawk. 3D Robotics pixhawk 14 stron.

Drukuj stronę
PARTS
1
1 Pixhawk
2 Buzzer
3 Safety switch
4 Micro-SD card and adapter
5 Micro-USB cable
6 Six-wire cable x2

GETTING STARTED

With the help of APM firmware, Pixhawk turns any
RC plane, copter, or rover into a full-featured personal
drone. Once you have a fully-assembled frame, follow
this guide to install Pixhawk.
1
MOUNT
Use the provided foam to mount Pixhawk as close as possible to your vehicle's center of gravity.
Make sure to orient the board with the arrow pointing forward.
Attach the foam squares to the
corners of the board.
2
3
8
9
4
5
10
11
7 Power module
8 I
C splitter module
2
9 Four-position I
C splitter cable
2
10 Three-wire servo cable
11 Mounting foam
1
Mount
2
Connect
3
Load firmware
4
Calibrate
Vehicle front
6
7